Exam Express EE0-426 Exam - OKExams.com

Free EE0-426 Sample Questions:

1. What criteria can be specified in a matching rule? (Choose THREE)
A. SSL URL
B. Set shaping Off
C. Diffserv marking
D. Set discovery On
E. VLAN identification
F. Application-specific criteria
Answer: CEF

2. What type of control features can be configured for folders?
A. Policies
B. Partitions
C. Policy Inheritance
D. Traffic Discovery within Class
Answer: B

3. What can a policy be applied to?
A. folder classes
B. class with children
C. class with no children
D. any class on the class tree
Answer: C

4. What best defines the functionality of Link State Mirroring?
A. PacketShaper will bring down the second port of a NIC pair if the first goes down.
B. PacketShaper mirrors data from an active interface set to a selected port to allow an external analyzer to be connected to take a packet trace.
C. PacketShaper duplicates data from an active interface and sends out the mirror port to the partner PacketShaper configured as the hot standby partner.
D. PacketShaper duplicates data from an active interface and sends out the mirror port to the partner PacketShaper configured as the direct standby partner.
Answer: A

5. What is the purpose of configuring direct standby?
A. to configure PacketShapers in one-armed mode
B. to monitor a connected router's WAN interface(s)
C. to configure PacketShapers in a redundant topology
D. to configure PacketShapers to participate in routing decisions
Answer: C

6. What best describes the capabilities available as part of the Packeteer unit high availability feature? (Choose TWO)
A. traffic discovery
B. automatic data back-up
C. non-inline traffic monitoring
D. automatic link capacity adjustment
E. insertion in redundant network topologies
Answer: DE

7. Why would the Failover feature in Setup be configured?
A. to detect if a Frame Relay PVC has failed and to adjust the link speed as appropriate
B. to detect if a site router's primary link has failed and to adjust the link speed as appropriate
C. to detect if a site router has failed and to configure a new site router IP address and link speed
D. to detect if a WAN router has become unavailable and to djust the total link speed as appropriate
Answer: B

8. What is the correct procedure to install a LAN Expansion Module in a PacketShaper for enabling direct standby?
A. Install in the lowest slot and use the inside port.
B. Install in the lowest slot and use the outside port.
C. Install in the most upper slot and use the inside port.
D. Install in the most upper slot and use the outside port.
Answer: D

9. What feature can be used to modify the amount of bandwidth available to an application based on the time of day?
A. Compression
B. Event Notification
C. Adaptive Response
D. Command Scheduling
Answer: D

10. What traffic will be classified with the matching rule shown?

A. traffic from the host with any address on the Inside to the host with IP address 10.10.4.31 on the Outside
B. traffic from the host with IP address 10.10.0.50, and on Port 5334 on the Inside going to the host with any address on the Outside
C. traffic to the host with IP address 10.10.0.50, and on Port 5334 on the Inside from the host with IP address 10.10.4.31 on the Outside
D. traffic from the host with IP address 10.10.4.31, and on Port 5334 on the Outside going to the host with IP address 10.10.0.50 on the Inside
Answer: C